Specifications

81
173
164
310
>
REMOTE MANAGEMENT SYSTEMS FOR ELECTRICAL BOARDS
The master module, designated ORBICOM, is an autonomous element that is ins-
talled on the lighting board and which performs the following functions:
• It measures the line voltage in true r.m.s. value between each phase and neutral,
reaches 255 V.
• It measures the active power in each of the three phases.
• Maximum current: 80 A per phase.
• It will calculate the cos φ for each of the three phases.
• It will calculate the active power in each of the three phases, between each phase
and neutral.
• It will calculate the total active power.
• It incorporates configurable astronomical switch on and switch off operations.
• It will measure the voltage in true r.m.s. value between each phase and neutral at
the lighting line outputs, when installed with ESDONI equipment, reaches 255 V.
• It calculates the savings for each phase in %, when installed with ESDONI equip-
ment.
• It calculates the total savings in % when installed with ESDONI equipment.
• Intruder, wiring theft and blown lamp alarms.
• Connection for up to 15 NODITEL units per RS-485 port.
• Direct event reading on the equipment display.
• Remote data transmission to a central unit over RS-232 modem, via GSM
modem, telephone wires etc.
• Remote programming of switch on and switch off in astronomical or fixed mode.
Reduc on/off voluntario: ON/OFF Voluntary reduction. The nodes designated NODI-
TEL are elements that are supplementary to the ORBICOM that enable system func-
tions to be to be expanded, acquiring data and transmitting them to the master.
Their most important specifications and functions are:
• Nodes that communicate with the ORBICOM via RS-485.
• Detection of fuse, breaker earth-leakage breaker failures etc.
(by detecting voltages of less than 160V R.M.S.).
• Each NODITEL includes DIP switches for address programming.
• The RS-485 can connect to a maximum of 15 NODITEL slaves.
• Direct power supply connection to the 230 V grid.
• When power is applied to the module, the green LED is switched on indicating
power is present. If there are no problems, the Green LED will flash at a rate of
0.5 seconds ON/1 second-OFF.
• If the unit detects a problem, for example, a missing or low (less than
160 V) phase, the red LED ROJO will flash at a higher rate (0.1 seconds Ton
and 0.1 seconds Toff).
• Each module can detect the voltage in up to three phases in the same line, which
is R, S and T with its neutral, or between phase and neutral in single-phase lines.
> 5 1 <
ORBICOM NODITEL
> Features
Rated line voltage
Measured voltage
Maximum current per phase
Frequency
Own consumption
Battery back up
Operational precision
Operating temperature
Precision accuracy class
Protection class
Protection type
Mechanical strength
Installation
3 x 230/400 Va.c.
3 x 230 Va.c. + N
80 A
50 Hz
Approx. 20 VA
6 years using a lithium battery
< ±0, 5 s/24 h at 23 ºC
-10 ºC to + 45 ºC
Class 1 active power - Class 2 reactive power
II adequate mounting
IP 51
IK 06
Fastening triangle in surface according to DIN 43857
> Features
Rated line voltage
Measured voltage
Alarm voltage per phase
Frequency
Own consumption
Operating temperature
Precision class
Protection class
Protection type
Mechanical strength
Installation
230 Va.c.
3 x 230 Va.c. + N
160 Va.c.
50 Hz
Approx. 5 VA
-10 ºC to + 45 ºC
Class 1
II adequate mounting
IP 20
IK 02
On the top of the symmetrical profile measu-
ring 35mm using EN60715. DIN Rail.
> Dimensions > Dimensions> Connection diagram
SYS ON
SMS
ASTRONOMIC
REDUC
ON-OFF
VOLUNTARY
BY - PASS
Weight: 2777 gr. Weight: 223 gr.