Installation Manual

Access Panel Installation
1. Run a power cable to the location where the Rently Access Panel 3
will be mounted. Remove the security screw from bottom of
Access Panel 3 with the wrench that is provided and take off the
mounting plate. Apply a bead of silicone around the area shown
before mounting the plate to the wall.
2. Insert the power and control cables through the mounting plate.
ǢȘqīÐĮĮĴìÐĉďķĊĴðĊæĨăĴÐťīĉăřæðĊĮĴĴìÐĉďķĊĴðĊæĮķīåÆÐĊÌ
secure with screws.
4. Connect the power and control cables from the Access Panel 3
according to the appropriate wiring diagram (see page 16).
ǤȘďĊĊÐÆĴĴìÐĊĴÐĊĊÅřĮÆīÐœðĊæďĊĴìÐÆďȭŘÆÅăÐȘAåĴìÐìķÅðĮ
nearby, you may use the 4 in antenna and tuck it into the wall. If a
stronger signal is required, the 6 ft antenna should be mounted in
a location free from large metal obstructions , including wire mesh
used for stucco.
6. Hook the top edge of the Access Panel 3 on the mounting plate
and swing the panel in until fully seated. Secure in place with the
security screw and provided wrench.
NOTE: Stow the provided security tool in an accessible location for
future service. A 6-lobe with center pin tamper resistant screw
driver may be used if needed.
ACCESS PANEL INSTALLATION 6