Installation Manual

LOCK TYPE INSTALLATION 15

The American Standard Electric Strike is normally set to a fail-safe

ÆďĊťæķīĴðďĊÅķĴĉřÅÐĉĊķăăřÆďĊťæķīÐÌĴďåðăȭĮÐÆķīÐÅř

following these steps:

2. Next, remove the two screws

holding the locking cylinder in

place. Slide the cylinder to the

second position as shown and

secure in place using the same

screws that were removed.

Note, you may need to slide

the wires through the zip tie

that holds them in place.

3. Depress the spring-loaded

locking tongue and

reassemble the bracket and

faceplate using the screws

that were removed.

1. Remove the two

screws holding the

faceplate using a star

wrench. Set the

faceplate and inner

bracket aside.