Installation Manual

Standard Mounting Method

1. Use the template provided to determine the correct location and

size of the mounting holes for both the door and frame header.

Ensure that the door opens away from the Maglock. In the case of

a single door, the Maglock should be positioned as close as

possible to the vertical section of the door jamb. Drill the door

and frame as indicated.

2. Loosely install the mounting plate using two of the supplied

Philips head mounting screws in the elongated slots. Attach the

Maglock to the mounting plate.

3. Using a hammer, lightly tap both roll pins into the armature plate

until they are secure. Before installing the Hex Nut, the hole in the

door may need to be drilled or tapped.

4. Using the components shown in the image to the right, mount the

armature to the door. Make sure that the armature plate is not

overtightened and that it is installed as shown in the following

diagram. The armature plate must be free to self-align with the

door.

Mounting Plate

Hexnut Bolt

Door Spacer

Rubber

Washer

Armature

Screw

LOCK TYPE INSTALLATION 12