Installation Manual

Slide the deadbolt assembly into the opening on

the side of the door with the “TOP” text oriented

properly. Install using the screws provided. Be sure

the deadbolt assembly is fully seated.

Arrange the corresponding rubber gaskets to be

fully seated against the back of the keypad and the

back of the mounting bracket. Feed the keypad

wire under the deadbolt hardware, then through

the cable hole in the mounting bracket.

Installation Instructions

Attach the mounting bracket to the faceplate using

two of the machine screws provided. Multiple screw

lengths are provided to accommodate the thickness

of your door. If necessary, you may rotate the cable

90° and hang the keypad from the bracket while

arranging your hardware.