en Index Safety instructions . . . . . . . . . . . . . Getting to know your appliance . . Water softener . . . . . . . . . . . . . . . . Filling the special salt container . . Filling the rinse-aid container . . . . Unsuitable dishes . . . . . . . . . . . . . Arranging crockery, glasses, etc. in the dishwasher . . . . . . . . . . . . . . Detergents . . . . . . . . . . . . . . . . . . . 4 6 7 8 9 10 11 15 auto 3in1 . . . . . . . . . . . . . . . . . . . . . Programme overview . . . . . . . . . .
en Safety instructions Delivery Immediately check the packaging and dishwasher for any damage which may have been caused in transit. Do not use a damaged appliance, but consult your supplier. Please dispose of packaging material properly: The corrugated cardboard consists mainly of waste paper. The polystyrene moulded parts have been foamed without any CFCs. The polyethylene film (PE) consists partly of secondary raw material.
en In daily use Warning Knives and other utensils with sharp points must be placed in the baskets either flat or with the points downwards. Use the dishwasher only in the household and only for its designed purpose, i.e. for washing domestic dishes. Do not lean or sit on the open door. The appliance could tip. The water in the appliance is not drinking water. Do not add any solvents to the washing chamber. Danger of explosion! Open the door carefully when the programme is still running.
en Getting to know your appliance Diagrams of the control panel and the interior of the appliance can be found in the envelope at the front. Individual positions are referred to in the text. Control panel 1 2 3 4 5 6 7 8 Main switch Door handle Numerical display Timer programming * Button for UPPER RACK washing function * Programme buttons LOW SALT indicator LOW RINSE-AID indicator Always keep the fascia clean and free of grease. Clean with a dry or moist cloth only.
en Water softener In order to rinse dishes and glasses satisfactorily, the dishwasher requires soft water, i.e. containing little or no lime, otherwise water stains will be left behind on crockery and glasses, etc. If the tap water exceeds a certain level of hardness, it must be softened, i.e. decalcified, so that it can be used in the dishwasher. This is achieved by adding a special salt to the water softener inside the dishwasher.
en Filling the special salt container How the salt works While washing is taking place, salt is automatically rinsed out of the salt container into the water softener where it dissolves the lime in the water. The dissolved lime is pumped out of the dishwasher. The water softening system is then ready for the next load. This process of regeneration can only function when the salt is dissolved in water. Unscrew the lid on the salt container 24 .
en Filling the rinse-aid container The purpose of a rinse-aid is to prevent the formation of water marks on tableware and utensils, and to ensure that glasses are clean and sparkling. The rinse-aid is consumed during the washing process. Fold back the lid on the rinse-aid container 29 . To open the lid, press the mark (1 ) on the rinse-aid lid and simultaneously lift the lid off the lug (2 ).
en Switching the rinse-aid indicator on or off You can switch the rinse-aid indicator 8 on or off. This function can be changed as follows: Close the door. Hold down programme button C and press main switch 1 until the digital display illuminates, then release the buttons. is On the digital display 3 indicated (rinse-aid indicator on). By pressing the programme button C you can switch the rinse-aid indicator off or on . Switch off the main switch 1 ; the chosen setting has now been stored.
en Damage to glassware and other dishes Possible causes: type of glass or manufacturing process chemical composition of detergent water temperature and duration of dishwasher programme. Suggested remedy: Use glassware or porcelain dishes that have been marked ’dishwasher–proof’ by the manufacturer. Use a mild detergent that is described as ’kind to dishes’. If necessary, seek further information from detergent manufacturers. Select a programme with as low a temperature and as short a duration as possible.
en Pots and pans Shelf * Lower basket * not on all models Lean tall glasses and those with long stems against the shelf – not against other items to be washed. 27 Cutlery Cutlery should be placed in the dishwasher always unsorted and with the eating surface pointing downwards. The spray jet is then better able to reach the individual parts. To prevent injuries, place long, pointed accessories and knives on the étagère (some models) or on the knife shelf (available as an accessory).
en Adjusting position of basket * * not on all models Ø max. 20/*25cm Pull out the top basket. Remove the top basket and re-attach it to the upper or lower rollers. 86cm 81cm Ø max. 20/*25cm Top basket with upper and lower roller pairs Ø max. 30/*25cm Ø max. 34/*29cm If required, the height of the top basket can be adjusted in order to create more space for large utensils either in the top or bottom basket.
en Baking sheet spray head * * some models You can clean large baking sheets or grilles with the baking sheet spray head. To do this, remove the top basket and insert the spray head as illustrated in the diagram. To raise the basket, take hold of the basket on the upper edge and pull upwards. Before you re-insert the basket, ensure that it is at the same height on both sides. Otherwise, the appliance door cannot be closed and the upper spray arm will not connect to the water circuit.
en Detergents Information about detergents You can use any brand of liquid or powder detergent, as well as tablets, that have been specifically designed for use in domestic dishwashers. (Do not use normal washing-up liquid!) Detergent compartment with measuring marks The side of the detergent compartment is marked with lines to help you determine how much powder to add. The capacity of the detergent container is 15 ml up to the bottom line and 25 ml up to the middle line.
en auto 3in1 Reduce costs! If you are using the upper rack only, or if your dishes are only moderately dirty, it will normally suffice to employ a reduced amount of detergent than otherwise recommended. Close the lid on the detergent compartment. Press down the lid (1) until it clicks shut (2). If you are using detergent in tablet form, read the manufacturer’s recommendations on the packaging in order to determine where the tablets should be placed inside the dishwasher (e.g.
en Note Optimum rinsing and drying results can be obtained by using standard detergents in conjunction with separate application of salt and rinse aid. Observance of the operating instructions or information on the packaging of the combined detergents determines their effectiveness. Note Even if the rinse aid and/or salt refill indicator is lit, the rinse programme runs correctly when 3in1 products are used.
en Programme overview This overview lists the max. possible number of programmes. The programmes supplied with your appliance are indicated on the fascia. Type of crockery e.g.china, Nonpots/pans, delicate cutlery, glasses, etc.
en Washing dishes Reduce costs! If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. Programme data The programme specifications can be found in the summary of instructions. Programme specifications refer to normal conditions.
en End of programme Changing the programme The programme has ended when a figure appears in the numerical display 3 . Several minutes after the programme has ended: Set the main switch 1 to OFF. Turn the water tap off. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down. It is possible to change the programme within 2 minutes after you have switched the dishwasher on.
en Maintenance and care You can help prevent faults by checking and maintaining your appliance regularly. This will save time and reduce problems. Therefore you should occasionally examine the inside of your dishwasher. Overall condition of the appliance Check the rinsing compartment for grease and limescale deposits. If you find any deposits: Fill the detergent dispenser with detergent. Start the empty appliance with the programme which has the highest rinsing temperature.
en Spray arms Lime and remnants of food in the washing water can block the nozzles in the spray arms 22 and 23 and the arm mountings . Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm 23 upwards and lift it off. Unscrew the upper spray arm 22 . Clean both spray arms under running water.
en Fault finding Resolving minor problems yourself Experience has shown that you can resolve most problems that arise during normal daily usage yourself, without having to call out a service engineer. Not only does this save costs, but it also means that the appliance is available for use again that much sooner. The following list of common occurrences and their remedies should help you identify the causes of most problems. Problems ... ... when the appliance is switched on The appliance does not start.
en Water remains inside appliance after programme has ended Blockage or kink in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait for the programme to end (numerical display will indicate 0). Perform “Reset” function. ... during washing Unusual amount of foam is created Normal washing up liquid has been poured into the rinse-aid container. Remove any spilled rinse aid with a cloth as it could otherwise lead to excessive foaming during the next washing cycle.
en Dishes, cutlery, etc. have not been dried Selected programme did not include drying function. Amount of rinse-aid was set too low. Items were removed from dishwasher too soon. Glasses have a dull appearance Amount of rinse-aid was set too low. Tea stains or traces of lipstick have not been completely removed Detergent does not have a sufficient bleaching effect. Washing temperature was set too low. Traces of rust on cutlery Cutlery is not sufficiently rustproof. Salt content in washing water is too high.
en Information Notes on comparison tests You will find details of the conditions for the comparison tests on the additional ”Notes on comparison tests” sheet. The consumption values for the relevant programmes are given in the introduction. Installation The dishwasher must be connected by a qualified technician to ensure correct operation. The specifications for supply, drainage and connected load must fulfil the required criteria as stated in the following paragraphs or in the installation instructions.
en Fresh water connection Removing the appliance Using the enclosed parts, connect the fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection is not kinked, crushed or twisted. When replacing the appliance, always connect a new water supply hose to the water supply. The old supply hose must not be re-used. Water pressure: Minimum 0,05 MPa (0,5 bar) – maximum 1 MPa (10 bar). If the water pressure is higher, install a pressure reducing valve.
en Protection from freezing temperatures If the appliance is installed in a location where there is a risk of freezing temperatures (e.g. in a holiday home), all water must be completely drained out of the interior (see “Transporting the dishwasher”). Turn OFF the tap, disconnect the supply hose and allow to drain.
en en Subjekt to modification 29
127 $33/,&$%/( 72 $33/,$1&(6 :,7+287 48$? 723 1 $'',7,21 72 :$55$17< &/$,06 $*$,167 7+( 6(//(5 %$6(' 21 7+( 6$/(6 $*5((0(17 $1' ,1 $'',7,21 72 285 $33/,$1&( :$55$17< :( 6+$// 5(3/$&( 7+( $33/,$1&( 81'(5 7+( )2//2:,1* &21',7,216 ) '$0$*( ,6 &$86(' %< :$7(5 '8( 72 $ 0$/)81&7,21 2) 285 48$? 723 6<67(0 :( 6+$// 0$.
