User Manual

4
STEP 2.2: MOUNTING - Retrofit Construction
Wall Mounted Installation (refer to Fig. C and Fig D):
1. Choose the optimal location.
NOTE: 11” minimum clearance required to mount the CON1001
Entertainment Box between studs. Use a stud finder to determine and mark
stud location behind surface of wall. Refer to Fig. C.
2. Use the front of the CON1001 Entertainment Box as a template to trace the
cut-out area on the wall. Refer to Fig. C. Use a wallboard saw to cut-out
the surface of the wall in that area.
NOTE: If you plan to attach a device box to the CON1001 Entertainment
Box, be sure to accomodate enough space for it. Refer to Fig. E. If there is
less than 14“ between studs, the CON1001 Entertainment Box will have to
be mounted in an offset position from their center-line.
3. Attach the low profile frame to the CON1001 Entertainment Box using four
(4) #6 Screws along with the four (4) Swing Clips prior to mounting. Refer
to Fig. D. DO NOT completely tighten scews at this point.
NOTE: For proper mounting to the wall, be sure to attach the Swing Clips
as illustrated in Fig. D.
4. Position the Swing Clips so that they are flat on the box and continue to
mount the CON1001 Entertainment Box into place. Refer to Fig. D. Now
tiughten all four screws making sure all four Swing Clips connect properly.
See Fig. D.
Figure C
trace along back front
Place a level along
the top of the box
Wallboard
edge of enclosure for template
[approx. 8.0" (20.3 cm) x 7.2" (18.0 cm)].
NOTE: If there is less than
14.0" (35.6 cm) clearance
between studs, mount box offset
from center-line of studs.
7.2
(18.0
cm)
8.0"
(20.3 cm)
11.0" (28.0 cm)
minimum
between studs
Figure D
#6 Screws (4)
Swing Clip (4)
Wallboard
(note orientation)
Low Profile Frame
See
Close-Up
Close-Up