User`s guide

Amulet High Definition Television Receiver User’s Guide



URC PLUS supports both RF and IR signals. You need to follow below procedures to program the URC

PLUS to IR mode before controlling Amulet.

1. On the URC PLUS, press and hold the “STB” button for approx. 5 seconds. The “STB” button backlight

will illuminate. Now the URC PLUS is in registration mode.

Figure 7-3 URC PLUS in Remote Registration Mode – Step 1 (for Amulet using IR mode)

2. On the URC PLUS, press “STB” once again. Both the “STB” and “AUX” button backlight will illuminate.

Figure 7-4 URC PLUS in Remote Registration Mode – Step 2 (for Amulet using IR mode)

Figure 7-5 URC PLUS in Remote Registration Mode – Step 3 (for Amulet using IR mode)

3. Press “0” to set URC PLUS to IR mode only. The URC PLUS will not send any RF signal.

The “STB” button backlight on the URC PLUS will blink twice to indicate that the setting was successful.

Pressing a key other than “0” or a button is not pressed within 10 seconds, the “STB” backlight will

extinguish and the URC PLUS registration process will be terminated.