User`s manual

19
5 Installation of intraskan dc
5.4 Scissor Arm Installation
• Remove the end cap by removing M3x6 self tapping CSK screws screw using screw driver and remove
the two bottom caps of the straight arm by removing M3x6 self tapping CSK screws (2 screws for each
cap) using screw driver as shown in Figure 23 .
• Remove the M8x25 positive lock screw along with M8 plane and spring washers using 6 mm allen key
as shown in Figure 24 .
The scissor arm with tube head attached is shipped tied close. Remove the securing cable tie
only when directed during installation. The scissor arm can spring open causing injury.
Always make sure to hold both arms of the assembly simultaneously while lifting or moving
the scissor arm.
Figure 23: Remove end cap and bottom caps (M3x6
self tapping Counter sunk screws )Use screw driver.
Figure 24: M8x25 positive lock screw
withspring&atwashers(Use6mm
Alley key).
• Route scissor-arm cables through the cou-
pler on top of the Straight Arm and install
scissor-arm with attached tube head into
the straight-arm (Use guide wire for routing
wires) as shown in Figure 25 .
• Cut the cable tie holding the scissor- arm
and open the scissor-arm.
• Fix the M8x25 positive lock screw along
with M8 plane and spring washers using 6
mm allen key as shown in Figure 24 .
Figure 25
Apply grease
as necessary.