User`s manual

10
4 Pre-Installation Requirements
4.1 Tools and Consumable Material
Table 4-1 provides a consolidated list of the tools and consumable material which are typically required
for executing the installation and service procedures provided by this manual.
4.2 Installation/Service/Maintenance Reporting Form
Every Equipment Installation/Service/Maintenance should be reported in the respective forms and check-
lists as annexed at the end of this manual. Additionally, it is mandatory to report every installation by filling
the Form FDA 2579 May 2010 and submitting it to:
FDA “Electronic Product Reports, Radiological Health Document Control (HFZ-309), Office of Communi-
cation, Education, and Radiation Programs, 9200 Corporate Blvd., Rockville, MD 20850,” or Any e-Sub-
mission as per FDA Guidelines.
4. Pre-Installation Requirements
4.3 Site Preparation
4.3.1 Site Survey
Make sure that the wall for mounting is strong enough for the installation and meet the support load re-
quirements of 4.4 Support Load Requirements.
Make sure that wall is levelled in both vertical and horizontal direction. Use a level indicator as shown
in Figure 2 and Figure 3 below. If the wall is not level, unit to be installed using additional 16" wall plate
(optional) and to be levelled by inserting shims as required between 16" wall plate and base unit plate.
Make sure that there shall be no electrical wiring conduits running around the area to be drilled for
the installation bolts.
Make sure that the reference hole of the base unit plate is at the height of 49" from the floor in both Single
stud mounting and two stud mounting as shown in Figure 4 and Figure 5. However this can change
based on site condition without affecting the functionality of the system.
Table 4-1. Useful Tools and Consumable Material
L- type allen Wrench Set including 2 mm,
2.5 mm,3 mm, 5 mm and 6 mm.
Hand-held Power Drill
1/2 inch Drive Socket Wrench with 8 mm
and 17 mm Sockets.
5/16" wood drill bit.
90 degree Circlip pliers.
Crimping tool with Dies 2035
Screwdrivers (Phillips & flat) Long nose Plies w/Cutter / Tweezers
Jeweler's Screwdrivers (Phillips & flat) ESD Wrist Wrap
Hook Wire for routing wire
Digital Multi-meter
Surface Level
Soldering Iron
Measuring Tape A Long Spirit Level with 3 indications
Lead Cup for Blocking Cone
Consumable Material
Grease & Waste Cotton Insulation Tape (if required for Trouble shooting)
Cable Ties & Mounts (if required) Solder (Lead) (if required for Trouble shooting)
Non-insulated Ferrule/Dowel Stud for wiring. Disposable Gloves (for applying grease)