Installation manual

Hardware installation2–9
If the “Select” button group will be used for system selection (delegation):
(1) Lift up the console top (see Figure 2–8). With power off, locate MPK (Select) panel DIP switch package
S1. This is an 8–position switch on the right–hand edge of the console.
(2) Set for “non–CE 300/SC 400 Control” (switch 8 OFF). (If switch 8 is OFF, all other switches are
ignored.) See Figure 2–37 on page 2–52.
If the “Select” button group will be used to operate a backup switcher, the DIP switch should have already
been set according to Step 8 above.
Figure 2–8. Turn screws clockwise to lift console top.
openopen