Installation manual

2–24 Hardware installation
HDVP Video Standard DIP Switch (S4) Settings
S4 is always effective when S14–6 is ON (as shown in Figure 2–21). It may or may not be effective when S14–6 is OFF,
depending on a table setting (as described on page 3–38).
Figure 2–20. DIP switch S4 settings. See page 2–22 for location of this switch.
1 0
0
0
0
0
1080i 60, 16x9, SMPTE 274M, ATSC Table 3 @ 1.5 Gb/s
0
0
0
1
1035i 60, 16x9, SMPTE 260M @ 1.5 Gb/s
720p 60, 16x9, SMPTE 296M, ATSC Table 3 @ 1.5 Gb/s
1
0
0
0
01
Leave OFF
0
Divide frame/field rate by 1.001
Do NOT divide frame/field rate by 1.001
0
1
1
1
0
1
0
1
270 Mb/s SMPTE 125M/259M (Mode 7)
270 Mb/s 625/50 (Mode 5)
0
0
1
0
1080i 50, SMPTE 274M
HDVP S4 Enable / Xilinx Configuration / JTAG DIP Switch Settings
Switches other than S14–6 are used for factory test and setup only. Default positions are shown in Figure 2–21.
Figure 2–21. HDVP Xilinx configuration DIP switch default settings. See page 2–22 for
location of these switches.
1 0
S7
1 0
S8
1 0
S10
1 0
S11
1 0
S12
1 0
S13
1 0
S14
01
Allow video standard
selection via S4 only
Allow video standard
selection via software
or S4 (see page 3–38)