Installation manual

Hardware installation2–23
Operational DIP Switch (S1) Settings
The CPU DIP switch S1 is normally used for factory test and setup only. Normal operation is for switch positions 1,
2, and 3 to be ‘ON’ with all other positions ‘OFF.’
Watchdog reset enable (default) 1
Watchdog off 0
1
0
Version 1.xx software
(psos)
not used
pROBE on Normal (default) 1
pROBE off (default) Clear flash 0
XRAY on Autostart on (default) 1
XRAY off (default) Autostart off 0
not used
not used
Figure 2–19. DIP switch S1 settings. See previous pages for location of this switch.
Version 2.xx and later software
(vx)