User manual

184 Element User Manual

{Dimmer Feedback} - appears when the current address is patched to a dimmer in an ETC Sensor

rack with a CEM+ or CEM3. Sensor feedback must be enabled. See Enable Sensor/ FDX3000

Feedback, page 248 and Errors and Warnings, page 75 for more information.

{Dimmer Feedback} displays the following information:

• Name (dimmer name)

• Module type

• Rack/Position

• Rack dimmer level (displayed as a percentage)

• Rack dimmer source

• Recorded load

• Actual load

{Dimmer Feedback} displays the following information, which can be modified from Element by

clicking on the value and entering in a new value:

• Firing Mode

• Control Mode

•Curve

• Threshold

• Scale Minimum

• Scale Maximum

• Preheat Enable

• Preheat Timing

• Advanced Features (AF) Enable

Element supports the following softkey commands from this display:

• {Ignore Errors}

• {Clear Errors}

Note:

For Sensor feedback, the CEM+ must be running software version 3.0 or later.

Note:

Clearing CEM+ / CEM3 errors from Element will be temporary unless the errors

have been fixed at the CEM+ / CEM3 Errors displayed on Element will clear on

their own once they have been cleared from the CEM+ / CEM3. Some CEM+ /

CEM3 errors can only be cleared at the CEM+ / CEM3.