User manual

96 Element User Manual

Flash

Using the {Flash} softkey in Live will alternate the intensity level for selected channels or addresses

between full and 15% output every second. The channel or address will keep flashing until either

the command line is cleared, or [Next]/[Last] is used to increment to the next channel or address.

• [1]{Flash} - will flash intensity for channel 1.

• [Next] - channel 1 returns to its previous state and the intensity for channel 2 will flash.

• [Dimmer/Address] [1][0]{Flash} - will flash intensity for address 10.

You can also use [Shift] & [Full] and [Shift] & [Out] to briefly flash levels. While [Shift] & [Full] is

depressed, selected channels will be held at full. While [Shift] & [Out] is depressed, selected

channels will be held at zero.

Moving Light Control

For more information about the ML Control display, see Moving Light Control, page 146. For more

information on programming moving lights, please see the Element tutorials

, http://