User's Manual

Federal Communications Commission (FCC) Statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION—Changes or modifications not expressly approved by the manufacturer could void
the user’s authority to operate the equipment.
Food and Drug Administration (FDA) Statements
This product complies with 21 CFR 1040.10 and 1040.11 except for conformance with IEC
60825-1 Ed. 3., as described in Laser Notice No. 56, dated May 8, 2019
Manufactured: MONTH AND YEAR
5
6 74
© 2020 ConserVention Inc. All rights Reserved. Patent Pending
5310 Buena Vista Dr, Frisco TX, 75034
www.smat.com
Regulatory
Normal Use
1) Turn SMAT ON
• If SMAT is OFF, press and the hold the
Power-and-Reset button until the Green Light
illuminates
2) To ensure SMAT is ON and functioning,
momentarily block one of the sensors with your
hand or an object and check for the following
indications:
• Red LED Status Indicator illuminates
• Audible “siren” warning tone
3) Gently slide the SMAT onto your hat visor using
the attachment clips.
4) Adjust the tilt of the sensor platform to ensure
proper sensor coverage around your face.
5) SMAT will alert you if you attempt to touch your
face under most circumstances
Charging the Battery
1) When the battery becomes critically low the
LED Battery Indicator will begin to flash.
2) Plug the USB cable into the charging port and
connect to a power source.
3) The LED Battery Indicator will be illuminated
while the battery is charging.
4) The LED Battery Indicator will turn off when the
battery is fully charged.
Troubleshooting Guide
❑ Adjust the tilt of the sensor platform to ensure
proper sensor coverage
❑ Ensure the sensors are clean and clear of
smudges, dust, or other obstructions.
❑ Adjust the positioning of your hat to ensure
the sensors are not detecting your chest or
shoulders
❑ Reset the device—Press and hold the
Power-and-Reset Button for greater than 6
seconds.
❑ Charge the battery
The following steps will correct most issues that
may be encountered while using SMAT:
Care and Maintenance
1) Keep the sensors clean
2) Do not force the attachment clips into position
3) Do not expose SMAT to extreme heat or cold
4) Do not disassemble or try to repair the SMAT
device, accessories or components. Doing so
may damage them.