Instructions

14
2.3 Pairing remotes with controller
• Enter "learning mode 1 or 2" (see section 2.2).
• Press and hold the “I” button on the remote for approx. 5 seconds (the green LED will
indicate activity).
• All connected LED lighting will turn on and the red LED on the controller will turn o.
• The remote and controller(s) are now paired.
• Repeat the above steps to pair any additional remotes.
2.4 Unpair a remote with controller(s)
• Enter "learning mode 1 or 2 (see section 2.2).
• Using the remote that you would like to unpair with the controller, press and hold the “O”
button for approximately 5 seconds.
• The green LED will flash once to indicate that the unpairing process has begun.
• The green LED on the remote will flash twice and the red LED on the controller will turn
o to indicate that the unpairing process has finished.
2.5 Reset a controller to factory default settings
On the paired remote, press and hold “3” and “4” for 5 seconds until the green LED on the
remote flashes once. All controllers will revert to factory default settings, and any settings
programmed by the user will be lost.
- Dual colour mode
- Cool white
- 100% brightness.
- Default (factory) frequency
Note
If a remote is only paired to one controller, press and hold "3" and "4" to revert back to
factory default settings. If a remote is paired to multiple controllers, refer to section "2.4
Unpair a remote with controller(s)" to unpair a remote and stay paired with any remaining
controllers.
-