Datasheet

Technical data: Value Unit
Operating voltage UB: typ. 12 V/DC
Operating voltage: max. 15 V/DC
Current consumption approx. 45 mA
Light source : Top View Chip LED
Viewing angle: 120 Degree
Luminous intensity: typ. 400/800 mcd per LED
PCB-dimension (L/W/H): 330 x 3 x 3 mm
Connections: 2 x isolated per approx.
Cu-strand 20 cm
LED-Strip-Board 330 mm for 12 V direct-current voltage
© Copyright 2012 by Conrad Electronic SE
RoHS
konform
Conrad
Electronic SE
Terminal assignment:
+V (red)
GND (black)
In the following drawing the possible seperations points of the LED-strip are marked.
When using the reduced LED strips, always use the part with the pre-manufactured connection wires first, because this contains the safety circuit.
Shorten it with a carpet knife by a groove at both sides, then break it carefully at the marked seperation points.
Attention: Do not bend the LED strip! This can cause damages on the solder terminals.
Extending the LED strip:
Seperation point 1 Seperation point 2
Seperation point 3
Please note the polarity when extending the LED strip!
Always connect one upper side with another upper side and one underside with another underside!
To dim the LEDs: DC 6... 12 V
PWM 50...100 %
12 V
0 V
Imprint
This data sheet is published by Conrad Electronic SE, Klaus-Conrad-Strasse 1, D-92240 Hirschau (www.conrad.com). All rights, including translation, reserved.
Reproduction of any type, e. g. photocopy, micro-filming or storage in computer systems, requires the written permission of the publisher. Reproduction, even in extracts,
Is not permitted. This data sheet reflects the technical specifications current at the time of printing. We reserve the right to change the technical or physical specifications.
Description:
The inflexible LED strip with super bright SMD-LEDs is a high-quality and low-priced solution for a
huge number of applications. Eight super bright ChipLED provide excellent brightness. The LED strip
has already been pre-manufactured with power cables. The current consumption is limited by
resistors and a diode protect the LEDs for wrong polarity. Through PWM (pulse-width modulation)
and also via reduction of the operating voltage it is possible to dim the LEDs. With the support of
marked separation points, the LED strip can be reduced in groups of two, four resp. six LED's.
45.0mm10mm 45.0mm 45.0mm 45.0mm 45.0mm 45.0mm 45.0mm
330.0mm
3,0 mm
77.5mm 90.0mm 90.0mm 90.0mm
The LED strips are not suitable for operation
with AC voltage (e.g. transformers).
This will damage the LED strips!
S
Article Nr.: 18 77 78 18 77 79 18 77 81 18 77 82
LED-color: red green amber blue
Luminous intensity: 6400 mcd 6400 mcd 6400 mcd 3200 mcd
Wavelength: 625 nm 523 nm 590 nm 470 nm