User manual

COMPONENTS IN THE
LEARNING PACKAGE
Find an overview of the parts contained in the learning package below.
1 IoT-WiFi-board (NanoESP)
1 pinboard
1 m circuit wire
2 button
1 9-V-clip
1 LED (red)
1 RGB-LED (4 connection legs)
1 resistor 10 kOhm (brown-black-orange)
1 resistor 1 kOhm (brown-black-red)
1 photo transistor (2 connection legs)
1 NTC 10 kOhm
1 Piezo speaker
1 potentiometer 10 kOhm with red dial switch
GETTING TO KNOW THE
MODULE
This first chapter is about the general functions of the WLAN-modules. The mod-
ule is controlled with AT commands. All example programs shown here, help and
further information can be found at www.iot.fkainka.de
It is easiest to download the entire ZIP directory and copy the unpacked folder into
your sketch folder completely. Then you can open all programs comfortably in
sequence from the Arduino interface.