User manual

Figure 61: Excess connection wire lengths must be cut off after completing and inspecting the circuit.
Figure 62: The cut connections should protrude over the PCB by 0.5 to 1 mm.
Figure 63: Cut off the connection wires closely to the solder cones.
4.18 De-soldering Components with Several Legs
Simple components like wire bridges or resistors can be de-soldered easily. This becomes
more difficult when a component like a transistor has several connections close together.
It is no longer sufficient to heat up one soldering point and pulling out the component
when the solder liquefies. You will need to use the de-soldering pump.
44