Manualshelf

User manual

ManualsBrandsCONRAD COMPONENTS ManualsScience KitsCourse material Basic Löten lernen 14 years and over
31323334353637383940
pincers so that its connections are located precisely on the contact surfaces. Keeping the
IC in position with the pincers, heat the connection on the pre-tinned pad. Now the SMD-
IC is attached. Solder on the other connections in sequence by placing the soldering tip
precisely and adding a little solder. Ensure that no conductive connection to the adjacent
soldering areas is created. Clean the soldering tip thoroughly after each soldering process
by wiping it at the moistened sponge.
Figure 48: SMD-IC under the magnifying glass - Pin 1 is marked with a circle here.
35