User manual

When de-soldering, make sure not to touch any adjacent solder points or components
with the hot soldering iron. Keep the de-soldering process short. The wire end should be
de-soldered within 5 seconds.
Figure 35: Pull slightly on the wire with your fingers while heating the soldering area, until the wire comes
loose.
4.8 De-soldering Soldered-In Wire Bridges
Proceed according to exercise 4.7. The difference is merely that you need to work precisely.
Wire bridges soldered into lands require very precise placement of the soldering tip so
that it does not touch any adjacent components. Lands may also come loose if heat is ap-
plied for too long. Therefore, try to complete de-soldering within a few seconds.
26