User manual

The solder sponge is one of the most important, as well as the most simple accessories of
the soldering iron. It is moistened with water and placed in the intended dish of the sol-
dering iron holder. Then you can clean the soldering tip by wiping off contaminations or
excess solder.
A fine mechanics’ clamp makes soldering easier. It can hold the PCB and keep it in the
position where work is easiest for you. This will leave your hands free for the soldering
iron and solder.
A de-soldering pump can be practical for de-soldering components. It looks like an over-
sized ballpoint pen. It is used to extract excess solder from the solder point.
Alternatively, you may also use de-soldering wires. They consist of thin, braided strands
and are available at different widths.
An electronics pliers set to bend components in shape and shorten excess lengths of con-
nection wires is also recommended. Pincers can be helpful for small SMD components, as
can a magnifying glass.
Figure 17: 15-W fine soldering iron by Conrad Electronic (order no: 588539-62);
this makes electronics soldering easiest.
14