User Manual

Doc P/N: 9040962 | Rev 01 | Printed 22 July 2016
50
CONNEX ProSight Installation and Operation Guide
Operating the Units|Setup Menu Options
Navigation pane
Detailed Overlay
Home Page
Safety
Introduction to CONNEX
ProSight
Opening the Package
Installing the Units
Operating the Units
The Detailed overlay displays the following information on top of the live
video:
• Transmitter name (1)
• Frequency mode (2)
• Signal level (3) – there are three levels:
» – best signal
1
T X _ 1
AUTO
2
3
Configuration Using
ProSight Desktop
Application
5
» – signal is weakening
» – it is recommended to bring the drone closer to the receiver
02m45s
15.8 V
4
Configuration Using
ProSight Mobile
Application
Specifications
Appendices
• Battery voltage (4) – blinks and turns red if the measured voltage is below the predefined threshold (see Setting Power Alert Threshold)
• Flight duration (5) – counts the flight time in seconds. Count start time depends on the following:
» When the HD transmitter telemetry port is connected to the flight controller, time starts counting when the drone is armed.
» When the telemetry port is not connected, time starts counting once the drone is powered on.