User Manual

Doc P/N: 9040962 | Rev 01 | Printed 22 July 2016
3
CONNEX ProSight Installation and Operation Guide
Safety|Safety Instructions
Navigation pane
Safety
Home Page
Safety
Introduction to CONNEX
ProSight
Opening the Package
Installing the Units
Operating the Units
Configuration Using
ProSight Desktop
Application
Configuration Using
ProSight Mobile
Application
Specifications
Appendices
Safety Instructions
• Do not open the HD transmitter or HD receiver enclosures. There are no user-serviceable parts inside. Refer servicing to qualified
service personnel only. The use of controls, adjustments or procedures other than those specified in this user guide may result in
exposure to shock and/or electrical or mechanical hazards.
• Do not immerse the units in water.
• Always disconnect a unit’s power by disconnecting the main plug.
• Clean with a dry cloth only.
• Keep powered on units at least 20 cm away from your body.
• Do not expose the units to moisture or excessive heat. Unit operating temperature is 32
0
F-113
0
F (0
0
C- 40
0
C).
• Unplug the units during lightning storms and long storage periods.
• For CONNEX ProSight receiver only – the provided power supply is for indoor use only.
• Use only the supplied accessories or those recommended on the AMIMON website. Accessories (including cables) must not be replaced,
as this may affect performance or functionality, or damage the unit. We highly recommend that you use the provided AMIMON cables. If
an alternate cable is used, make sure that it is of the highest quality.
• Do not use the product if there is any physical damage to the enclosure.
• For CONNEX ProSight transmitter only – it is normal for the transmitter to become slightly hot during use. However, if the enclosure’s
temperature becomes too hot to touch, turn the transmitter off and contact support.
• Do not let the product come into contact with corrosive materials.
• Do not let the product come into contact with fire.