Installation Guide
7
CTKFT33_IG_v1
INSTALLATION GUIDE - WIRING
See Wiring Diagram on Pg.4 for more information
Before installing the interface, the factory stereo must be removed and disconnected. To do this, please consult the vehicle
owner’s manual/handbook or contact a tting professional.
For universal patch leads, prepare the wiring loops in accordance with the instruction manual supplied before installation.
2. Connect the opposite end of the stereo connection (patch) lead to the steering wheel control input on the back of
the aftermarket stereo.
NOTE: This may be a 3.5mm jack connector or a wired input depending on the brand of aftermarket stereo being tted.
Please consult the aftermarket stereo installation manual for further information on where to make the connection.
IMPORTANT: THIS STEP MUST BE COMPLETED BEFORE CONNECTING POWER TO THE INTERFACE.
FAILURE TO DO SO MAY RESULT IN A LACK OF FUNCTIONALITY AND THE NEED TO REINSTALL THE PRODUCT
!
3. Connect the 14 Pin connector from the supplied wiring loom to the interface box.
1. Connect the 12 Pin connector from the stereo connection (patch) lead to the interface box.
4. Connect the power/speaker ISO connector to the power/speaker ISO connector at the rear of aftermarket stereo.
Note: For aftermarket stereos which do not have an ISO connector, please see ‘Wiring Key’ on Pg.2 for information on which wires to connect.
11. Test stereo and steering wheel control functionality for correct operation before reassembling the vehicle
dashboard. If steering wheel control functions are unresponsive, please uninstall the interface and wiring and
reinstall carefully in accordance with the above steps.
For further help, please contact and ll out a support ticket with the full details of your issue at:
support.connects2.com/tickets/technical
9. Connect the vehicle specic connector on the supplied harness to the OEM connector from the vehicle.
8. If tting an aftermarket reverse camera, connect the cameras RCA to the female Yellow RCA connector on the
extension lead.
If you are retaining the OEM reverse camera, connect the RCA on the harness to the female Yellow RCA connector on
the extension lead.
6. Connect 4 Pin camera extension harness to the interface box.
7. Connect the male Yellow RCA from the camera extension harness to the reverse camera input of the aftermarket
head unit.
10. Connect the vehicle specic antenna supplied between the OEM connector from the vehicle and the rear of the
new stereo.
5. Connect any additional ying wires from the harness to the head unit as required.
Note: Additional ‘flying’ wires can be connected to the vehicle to support various features i.e. parking brake trigger, reverse gear and speed
pulse. Details of these can be found under ‘Additional Connections’.
The Infodapters ‘Conguration menu’ showcases a series
of options and settings that can be altered to tailor the
users experience. To navigate these options, use the
‘Track Up’ & ‘Track Down’ buttons (Fig.6 & 7).
ACCESSING CONFIGURATION MENU
Conguration Menu
Vehicle Settings
Infodapter Settings
Language
Version
< Back
Once the CTKFT32 has been installed into the vehicle successfully, simply hold the ‘Speech’ button (Fig.4)
on the steering wheel to access the ‘Conguration Menu’.