User`s manual

Master Audio
PA208A.Ver 1.1 Nov 09 19
Usually, the HFC switch on the connection panel should be set at -3 dB when a single
speaker is used.
Fig.6. Single unit on tripod
4.3. Several units of PA-208A
Flying several units of PA-208A is easy, fast and secure. To perform any operations
related to flying the system, read the present document, and act on the warnings and
advice given.
Only experienced installers with adequate knowledge of the system and local safety
regulations should fly speaker cabinets.
It is the user's responsibility to ensure that the systems to be flown and the flying
accessories (such as chains, eyebolts, lock pins...) comply with state and local
regulations. They should be regularly inspected and replaced if in doubt.
When flying enclosures from ceiling support structures, extreme care should be taken
to assure the load bearing capabilities of the structures. Do not fly systems from
unsafe structures.
All flying accessories that are not supplied by Amate Electroacústica are the user's
responsibility. Use at your own risk.
Remember that no risks should be taken with regards to public safety.
KR-208A optional kit must be used to fly a complete PA-208A system. This hardware
is manufactured from steel with black paint finish; they are affixed to the box with
special crop resistant screws. Fore more information read “KR-208A” user manual (at
www.master-audio.com)