Specifications

Chapter 3: Configuring the ConnectPro Server 9
• Terminate the connection if the host sends data while no client is connected to
TermProxy.Thisoptiondisconnectstheproxy-hostconnectioniftheClientis
unavailableforinformationsentfromthehost.
• Reconnect String.SendsaspecifickeypresstothehostwhentheClientreconnects.For
example,theClientcansendakeypressthatwillnavigatetoamainmenuwhenthe
Clientreconnects.
Whenyouhaveconfiguredtheoptions,clickNext.
3 TheStep2:ProxyServicepageappears.Configurethefollowingoptions:
• Proxy Address.TheaddresstheConnectProserverwillbindto.Youcanspecifya
proxyaddressof 0.0.0.0 ifyoudonotwanttolimitthenetworkinterfaces
ConnectProcanuse.
• Proxy Port.TheportthattheClientsusetoconnecttotheConnectProserver.
• Timeout.TheamountoftimetheConnectProserverwillwaitafteraClienthasbeen
disconnectedbeforeitwilldisconnecttheproxy-hostsession.
• Clients may connect through a Network Access Translation (NAT) device.Enable
thisoptiontoensurethatsessionsarenotdisconnectedprematurelywhenusingaNAT
device.
WhenaClientconnectstoConnectPro,theConnectProservercheckstoseeifthereare
anysessionsfortheClient’sIPaddress.IftheClientisnotawareofanysavedsessions,
ConnectProwill,bydefault,closeanysessionsusingthesameIPaddress.However,if
multipleclientscanhavethesameIPaddress,sessionsforotherClientscouldbeclosed
prematurelywhenanewClientconnects.Whenthisoptionisenabled,ConnectProwill
notclosecurrentsessions.
• Compress data sent to newer Clients.Thisoptioncompressesanyblockofdatalarger
than500bytessenttoClientsthatareversion7.2.12ornewer.Youcanhave
compressionenabledwhenusingClientsolderthan7.2.12,butthedatasenttothose
Clientswillnotbecompressed.
• Encryption.ThisencryptsthesessionbetweentheConnectProServerandtheClient.If
youareusingSSH,youmustchangethissetting.AvailableoptionsareSSL/TLS,and
CustomEncryption(aproprietaryWavelinkencryptionmethod).
• Custom Encryption Passphrase.IfyouuseCustomEncryption,provideapassphrase
tobeusedbetweentheClientandtheConnectProserver.Thisshouldmatchthe
customencryptionpassphrasesuppliedtotheClientintheemulationparameters.
Whenyouhaveconfiguredtheoptions,clickNext.
4 TheStep3:HTTPServerpageappears.Configurethefollowingoptions: