Installation guide

Starting the Jabber XCP Controller
Jabber XCP Server Installation Guide Installing the Jabber XCP Server Page 27
Beta Version Only
Starting the Jabber XCP Controller
The Jabber XCP Controller is a web-based interface that is used to configure the Jabber
XCP server. This section describes how to start the Controller and access it in a browser
window.
To start the Jabber XCP Controller
1. Change to the $JABBER_HOME/bin directory.
2. At the command line, enter:
./runcontroller start
3. Using a web browser, connect to the Jabber XCP Controller using the server name or
IP address, and the port that you provided during the installation (the format is shown
below).
https://[xcp_server_IP]:[controller_port]/admin
For example:
https://127.0.0.1:7300/admin
4. Click OK or Yes when you see the message about using an unknown authority or that
there is a problem with the security certificate. (If you are using Mozilla Firefox, you
see the dialog shown in the following figure. If you are using IE 6, you see the
Security Alert dialog.) This message is shown because you are connecting via SSL,
and the certificate is being signed by Jabber, Inc., which is not a certificate authority.
If you entered a URL containing the server’s hostname rather
than the IP address, you may see an error like the one shown in
the following figure. The free certificate that Jabber, Inc. supplies
is for the IP address of the machine on which you installed the