User`s manual

CHANNEL STRIPS
4 – Meter Section (for both channels)
The meter indicates the input level. The best signal to
noiseratioisachievedwhenpeaksareascloseto0dBas
possiblewithoutclipping.AdjustthegainusingtheGAIN
knobs on the Desktop Konnekt 6 and the output level of
the external source.
5 – Pan/Balance
When the “Mic+Inst” or the “Inst+Inst” scene is
selected, this knob acts as the pan control for a channel.
When the “Stereo In” scene is selected, this knob acts as
a balance control between left and right channel.
6 – Send
This is the Effects Send knob for the M40 Studio Reverb.
MICROPHONE CHANNEL
The following parameters are relevant for the
microphone channel only.
7 – 48V Phantom Power
Activate 48V phantom power when connecting a
condenser microphone to the Desktop Konnekt 6.
8 – Boost
Formicrophoneswithaparticularlylowoutput,theBoost
shouldbeactivated.Thiswillboostthesignalby12dB.
9 – Labels
The mixer-channels have default labels. However, these
can be altered as you wish. Simply click on the channel
label and enter a name of your choice.
MIXER PAGE MIXER PAGE
1514
CONTROL PANEL
• PresstheMixertabtoentertheMixerpage.
• Tochangepositionofknobsandfaders:Pressand
hold the left mouse button and move the mouse up or
down.
In this section of the Mixer page, you select between
three scenes.
Scenes are “setup presets” that include:
- 48V on/off
- Booston/off
- Pan button position
- Effects send button position
- Reverb settings.
As soon as a scene is changed, the new settings will
be assigned to that scene. There is no additional store
procedure.
1 – Scene – MIC+INST
TheMIC(XLR)andtheLINE/INSTRIGHTinputsare
selected.
2 – Scene – INST+INST
TheLINE/INSTRIGHTandLINE/INSTLEFTinstrument
inputs are selected. The two channels are treated as two
separate mono channels.
3 – Scene – STEREO IN
TheLINE/INSTRIGHTandLINE/INSTLEFTinstrument
inputs are selected. The two channels are treated as a
stereo input.
When you work with a variety of recording sources,
you do not have to change the routing every time:
You can leave microphone and instruments
connected to the three recording inputs all the time.
InputselectionisdoneusingtheSCENEbuttons.