Specifications

Installation Instructions
X2O Winches
Installing the control box
 It is recommended to install you winch control box prior to installing your winch.
 You may install the control box in a separate location using 3-4 AWG marine cable (not
included)
 Determine if you want your control box located over the motor (side) or the drum (Center)
DRUM (Center Mount)
Step 1: Install the two included zinc brackets on the bottom of the control box by removing the
four nuts on the bottom of the box, then placing the brackets over the bolts and then
secure brackets by re-installing the nut. (Fig A) (Note: The hooks on the brackets go
towards the front of the winch.) Use caution when installing brackets in order not to push
the bolts up into the control box. To help prevent this, install brackets with the control box
on its side instead of laying it flat on a table.
Step 2: Secure the brackets to the winch by placing the front hooks on the brackets around the
front tie-rod then push the rear down over the rear tie-rods. Secure by tightening the
the screw on the rear of each bracket (Fig B)
(Fig A) (Fig B)
MOTOR (Side Mount)
Step 1: Install the two black motor mount brackets on the bottom of the control box by removing
the four nuts on the bottom of the box, then placing the brackets over the bolts and then
secure brackets by re-installing the nut. Note: The end of the brackets point outward.
(Fig D) Use caution when installing brackets in order not to push
the bolts up into the control box. To help prevent this, install brackets with the control box
on its side instead of laying it flat on a table.