Specifications

Installation Instructions
X2O Winches
Lubrication installation
All moving parts in the winch are permanently lubricated with high temperature lithium grease
at the time of assembly. Lubricate cable periodically using light penetrating oil. Inspect for broken
strands and replace if necessary. If the cable becomes worn or damaged it must be replaced.
Cable installation
Unwind the new cable by rolling it along the ground, to prevent kinking. Remove old cable and
observe the manner in which it is attached to the cable drum flange.
Electrical Connection (8000 ,10000,12000,)
For normal self-recovery work, your existing electrical system is adequate. A fully charged
battery and proper connections are essential. Run the vehicle engine during winching operations to
keep battery charged.
Pay close attention to proper electrical cable connection as follows (Refer to diagram 1)
1. Short red cable (B’) connecting to the red terminal (B) of the motor.
2. Short black cable with yellow jacket (C’) connecting to the yellow terminal(C) of the motor.
3. Short black cable with black jacket (D’) connecting to the black terminal (D) of the motor.
The thin black cable (a’) connecting to bottom terminal (A) of the motor
4. Long black cable (1.8m), one terminal (A’) connecting to the bottom terminal (A) of the
motor, and the other terminal negative (-) connecting to negative (-) terminal of battery.
5. Long red cable positive (+) connecting to positive (+) terminal of battery.
Electrical connection (15,000)
1. Long black cable (1.8m), one
terminal (A’) connecting to the
bottom terminal (A) of the motor, and
the other terminal negative (-)
connecting to negative (-) terminal of
battery.
2. Long red cable positive (+)
connecting to positive (+) terminal of
battery.