Specifications

Installation Instructions
X2O Winches
Gear Housing “Clocking”
In some situations you may need to “Clock” (turn) your Gear Housing in order to gain access
to them.
To clock the Gear Box
Step 1: Loose the tie
rods to take the gear
box
Step 2: take off the retaining
bolts (totally 10pcs)
Retaining
Step 3: get the gear
box rotated; then
connect the gear box
Note pls: the rotation of
gear box must be 36
degrees, or a degree
which is the multiple of
Step 1: Loosen and remove the two tie
rod bolts on the gear box side.
Step 2:
Remove the small retaining bolts on the
inside of the gear box
Step 3: Rotate the gear box to the
optimal position needed. Then re-install
the retaining bolts and re connect gear
box to the tie-rod bars.
Note: “Clocking” must be done in 36
degree intervals due to the position of
the retaining bolt holes.