User`s manual

30
Here are descriptions of every setup item:
Select Click the radio button to select the access point.
Channel Display to channel number of the access point.
SSID Display the SSID name of the access point.
BSSID Display the BSSID (MAC Address) of the access
point.
Encryption Display the encryption setting of the access points.
If you have selected the access point with security
setting, you have to go to ‘2-7 Wireless Security’ to
set the same security with the access point you
want to associate.
Authentication Display the authentication type of the access point.
Signal The signal strength of each access point will be
displayed here. The signal strength is stronger, the
connection quality is better.
Mode Display the wireless modes include 11b, 11b/g or
11b/g/n or 11n only of the access points.
Refresh Click this button to refresh the table.
Connection Select an access point and click this button to
choose the network. The SSID name of the access
point you have selected will be displayed in the
Main SSID in the Basic Setting page.
2-4-3 AP Bridge-Point to Point Mode
In this mode, this wireless access point will connect to another wireless
access point which uses the same mode, and all wired Ethernet clients of
both wireless access points will be connected together. You can use this
mode to connect a network to another network which is physically
isolated.
Please note that when you set your access point to this mode, it will not
accept regular wireless clients anymore.
When you select ‘AP Bridge-Point to Point’, the following options will
be displayed: