Operator`s manual

Adjusting instrument cluster
illumination
You can adjust the illumination of the
switches, the dials in the instrument
cluster, the radio*, the climate control*
panel and the auxiliaryinstruments*. Five
illumination levels are available.
X
Make sure the key is in starter switch
position 1.
X
Switch on the parking lamps.
X
To brighten or dim illumination: Press
button : on the instrument cluster
repeatedly until the desired setting is
reached.
The current setting is stored.
Control system*
Introduction
The control system is activated when you
turn the key in the starter switch to
position 1.
G
WARNING
Adriver’s attention to the road and traffic
conditions must always be his/her primary
focus when driving.
In order to avoid distraction which could
lead to an accident, the driver should
select features and change settings in the
control system only vehicle at a standstill
or when traffic and road conditions permit
it to be done safely.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h ), your vehicle is
covering adistance of 44 feet
(approximately 14 m) every second.
Control lever
You can select the displays in the
multifunction display and change settings
in the control system with the control
lever.
Control lever (example illustration coupé)
:
Control switch
Pressing up selects a menu.
;
OK button
Confirming a selection.
Scrolling through stored messages
in the Messages menu
=
Control switch
Pressing down selects a menu.
Multifunction display
The multifunction display shows values and
settings as well as display messages.
X
Activating the multifunction display:
Turn the key to starter switch position 1.
X
Confirming messages: Press the OK
button on the control lever (Y page 92)
briefly.
X
Exiting menu: Press the control switch on
the control lever (Y page 92) up or down
92
Control system*
>> Controls.
* optional