User`s manual

User's Manual
PrintSir is to be located. The PrintSir will obtain its IP address
automatically by the protocol DHCP, BOOTP, RARP if you configure
the IP address as Auto. Click Save to PrintSir button to save the
configuration to the PrintSir.
The PrintSir will verify your password (it will ignore the User
Name item) when you save the configuration. Make sure to reset the
PrintSir (described in section 8.3.11 System Utilities ) to let the
changes take effect.
8.3.8
Configuring DHCP Parameters
The PrintSir can be configured as DHCP server to provide
dynamic IP addresses assignment. The DHCP Cfg page allows you to
set:
z
The DHCP server startup, which determine if the PrintSir will
act as DHCP server. If this item is set to Auto, the PrintSir
will detect if there is any other DHCP server on the network
when it boots up. If there is no DHCP server on the network,
then the PrintSir will configure itself as DHCP server;
otherwise it will disable this function.
z
DHCP setting is used to configure TCP/IP parameters that
will be assigned to a DHCP client. If this item is set to Auto,
the PrintSir will determine all TCP/IP parameters
automatically; otherwise you will configure the following
parameters:
 Starting IP: specifies the starting IP address for assigning
to DHCP clients.