User's Manual

PAGE 4 / 6
1. Place the BLUETREK® E2 and your mobile phone within 0.3 meter (1 foot) from
each other.
2. Switch on your phone and select its Bluetooth® discover mode (refer to the
Bluetooth® mobile phone user manual).
3. When the BLUETREK® E2 is switched off, press and hold the TALK button for
about 7 seconds until the indicator light flashes red and blue alternatively. And a
sound can be heard in the speaker.
4. Once the mobile phone detects the headset, a “BLUETREK E2” message will be
displayed. Follow the phone instructions to accept the pairing. The PIN code (or
passkey) is 0000, then press “yes” or “ok”.
If pairing was successful, the indicator light will switch to blue and flashes slowly.
If you haven’t started the discovery mode within 5 minutes, the headset will switch off.
You must then switch on your headset and start the pairing again.
Wearing the BLUETREK® E2
For your convenience, the ear clamp of BLUETREK E2 is designed to be adjustable and
removable which allows the headset to be worn on either ear comfortably. BLUETREK®
E2, as packaged, is ready to be worn on your right ear.
For left ear, simply unsnap the ear clamp from the headset by pulling gently at the base
of the ear clamp ring. Flip the ear clamp over, and snap it back onto the headset by
applying gentle pressure on the base of the ear clamp ring. Make sure the speaker is
properly inserted into your ear.
Switching the BLUETREK® E2 ON and OFF
Switching BLUETREK® E2 ON
When your headset is off, press and hold the TALK button for about 2 seconds until the
blue indicator light is on. A beep (2 tones) can be heard in the speaker. Release the
TALK Button.
To check if your headset is ON, press once on the TALK button. If the indicator light
flashes blue, it means your headset is ON.
Switching BLUETREK® E2 OFF
When your headset is on, press and hold the TALK button for about 5 seconds until the
red indicator light is on after the quick blue flashes. A beep (2 tones) can be heard in the
speaker then release the TALK Button.
Making a call
Mobile phone with voice recognition
. Make sure the voice recognition function on your mobile is activated and your voice
tags have been recorded with the phone. To enter these, please refer to your phone’s
manual
. When there is no incoming or active call, press once on the TALK button
. Wait for the audio signal sent by the mobile phone (generally a short tone).
. Speak the name of person you wish to call.