User Manual

Dongle User’Guide Aug02/BtrekRefV1/GpoV1
5. Pairing
Before using the dongle with an headset, you must pair it with a BlueTooth headset like
Bluetrek.
Pairing is the process of linking two BlueTooth devices, so that they can be connected to
each other with a worlwide unique link.
IMPORTANT
: before pairing all Bluetooth devices have to be switched off.
5.1. Pairing the Dongle to BlueTrek
To initiate the pairing :
1- Put your Bluetrek into pairing mode (please refer to the Bluetrek manual)
2- Put your dongle into pairing mode (please refer to the paragraph 4.1.3)
3- After few seconds, when the pairing has been completed, in both side, the
green led flashes slowly. You are now in standby mode.
5.2. Pairing the Dongle to a BlueTooth Headset
To initiate a pairing with a BlueTooth Headset :
1- Put your BlueTooth Headset in the Pairing Mode (See your BlueTooth headset
user’s manual)
2- Put your dongle into pairing mode (please refer to the paragraph 4.1.3)
3- After few seconds, when the pairing has been completed, the green led flashes
slowly on your dongle. You are now in standby mode.
5.3. Checking if the Pairing is correct with Bluetrek
Your headset and your dongle are in standby mode. Your dongle doesn’t need to have
the cable. Press 2 to 3 seconds one of the button on Blutrek until you can hear a bitone.
Then release the button and wait. After few seconds you should be able to see the green
LED of the dongle lights on continuously for about 1 second. At the same time you could
hear something like wind in the headset speaker.
Page 9 of 16
Innovi Technologies Ltd
Suite 501-3, 5/F, Chinachem Leighton Plaza, 29 Leighton Road, Causeway Bay, Hong Kong
Tel: [phone], Fax: [phone]
Email: [e-mail]
, Web: www.innovi.com