User Manual

Dongle User’Guide Aug02/BtrekRefV1/GpoV1
The dongle is in this mode when you see the red LED on and flashes on the green LED.
Each flash in quick succession means the profile number. For example one quick flash
means profile numer one, three flashes in quick succession mean profile number 3 etc.
There are 5 possible profiles. So you have 5 differents type of flashes on the green light.
To go to profiles mode be sure first your dongle is switched off. Then press the button for
around 14 seconds until you see the red LED on together with quick green flashes. Now
you can release the button. Be carefull not to be confused with the beginning of the
standby mode which indicates only once the default profile. So you have to keep pressed
the button in order to pass through the standby mode and the pairing mode then you
access the profiles mode.
To change the profile you have first to be in profiles mode. Then observe the number of
green flashes. For example 2 quick flashes means you are in profile number 2. If you
press the button once (quick pres) so you will go to the next profile. In our example you
can see now 3 quick flashes. Then one more press you go to the profile 4 and so on.
After profile number 5 you go to profile number 1. Actually you browse in a loop until you
access the required profile.
After choosing the right profile you have to save it as the default profile by switching off
your dongle. So please press few seconds until you see the 2 LED on continuously. Then
release the button. Your dongle is now off.
To check if everything is good you switch on your dongle then you can see the number of
green flashes telling you the default profile you’ve just programmed.
Page 8 of 16
Innovi Technologies Ltd
Suite 501-3, 5/F, Chinachem Leighton Plaza, 29 Leighton Road, Causeway Bay, Hong Kong
Tel: [phone], Fax: [phone]
Email: [e-mail]
, Web: www.innovi.com