Bluetrek Bluetooth Wireless Headset for mobile phones User Guide
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution : Changes or modifications to this Bluetooth headset not expressly approved by the manufacturer could void the user's authority to operate the equipment.
1. Introduction BlueTrek is a wireless Headset for mobile phones. It uses the Bluetooth Technology, a new standard for wireless short distance radio communications. Devices like a headset and a mobile phone can communicate with each other without wires within approximately 10 meters. BlueTrek Headset is a qualified Bluetooth headset that complies with the Bluetooth 1.1 protocol.
Microphone Adjustable speaker 3. Charging BlueTrek Your Headset is delivered uncharged. So before you start to use Bluetrek, you must fully recharge it for about 2 hours. It is mandatory to use the charger provided with your product. The use of any other charger will automatically suspend the warranty. Plug the charger jack into the Headset. Because the jack is new, it is harder to plug when you start to use it. So please make sure you push it completely.
4. Pairing Bluetrek headset to a Bluetooth mobile phone Before using the BlueTrek Headset, you must pair it with your BlueTooth mobile phone. Pairing is the process of linking two BlueTooth devices, so that they can communicate. The pairing only needs to be done once. Afterwards, every time you switch on your Headset, it will automatically connect to your mobile phone.
5. Wearing the headset Please refer to Figure 2. FIGURE 2 The headset can be used in both ears. Hold the headset with the opposite hand while holding your ear with the other hand. For instance, if you want to place the headset on your left ear, hold the headset with your right hand while holding your ear with your left hand. While holding the headset, pull slightly the small speaker away from your ear and place the headset on your ear as shown on the picture.
Position the headset properly on your ear and then release the speaker. Finally, make sure that the speaker fits well into your ear. At this stage it should be stable and comfortable. Your headset is now ready. 6. Switching the Headset ON and OFF: 6.a. Switching the Headset ON : If you Headset is switched OFF, press button 1 for about 3 seconds until the light flashes green and red, and you will hear a music tone in the speaker. Your Headset is now ready to make and receive calls. 6.b.
7. Making a Call Preliminary remark: The voice recognition feature is not available on all mobile phones. However you can always dial directly on your keypad. If your mobile phone offers the voice recognition feature, you can make a call directly from the headset without any operation on you mobile phone. Mobile with voice recognition: 1. Make sure the voice recognition function on your mobile is activated and your voice tags have been recorded. 2.
10. Incoming Call When you receive a call: 1. The green led flashes quickly (red led is used if the Battery Voltage is low) on BlueTrek headset 2. A ring tone is audible at the BlueTrek headset To answer the call presses shortly any button on the BlueTrek Headset for about 1 second until you hear a tone. The light will flash green slowly (or red if battery is low) on the BlueTrek Headset. 11.
- Do not let children play with your Headset, since it contains small parts that could become detached and create a choking hazard. Check the regulation in you area if you plan to use your Headset while driving. Turn off your Headset before boarding an airplane.
