Users Manual

Page | 52
Clicking on the unit serial number in the Table view opens the Information view of that
unit. The relay status is depicted as shown in FIGURE 50.
FIGURE 50
i
NOTE The button at the top right shown in FIGURE 51 changed from “Open Relay” to
“Shut Relay” as soon as the batch action was initiated. An Admin user can use this button to
cancel the batch action (Open Relay) command before the top of the hour.
FIGURE 51
7. Select “Shut Relay” to shut the internal ConnectDER relay on selected units. A “Relay
Shut requested” message appears for five seconds as shown in FIGURE 52. The
relay will shut at the top of the next hour.
FIGURE 52.