Users Manual
Page | 42
APPLYING FILTERS TO UNITS
Filters may be applied to narrow down unit search criteria.
In “Chart” view, filters reduce the number of units displaying data.
In “Table” view, filters reduce the number of units listed for further action by the Admin.
In “Map” view, filters reduce the number of units displayed on the map.
No filters are applied by default. All units are displayed. Refer to FIGURE 39 for an
explanation of the default conditions.
Filters are additive. In other words, the more filters applied, the more selective the
results.
FIGURE 39
“Any” means units in all states are displayed, subject to
other filters.
Blank “UNIT S/N” means no serial numbers (or parts of
serial numbers) are filtered.
Blank “MODEL#” means no models numbers (or parts of
model numbers are filtered.
“Any” displays units provisioned by all installers, subject
to other filters.
Clear check boxes mean all units are displayed
regardless if they have a tag or not.
“Any” means all relay states are displayed, subject to
other filters.
“Any” means all units are displayed, subject to other
filters.
Clear check boxes mean both meter forms are displayed.
Blank field displays all units, subject to other filters.
Blank “IP ADDRESS” means no IP addresses (or partial
IP addresses) are filtered
Remember, filters are effective only after clicking “Apply”.