Users Manual

Page | 4
INTRODUCTION
The SMART ConnectDER™ is UL Listed equipment that enables rapid interconnection of
grid-ready distributed energy resources (DERs). The device creates a safe, standardized,
low cost alternative to traditional wiring methods. It contains onboard metering,
communications, and controls to unlock alternative tariff models and grid management
capabilities.
The SMART ConnectDER operates in parallel with the utility grid. It is approved for use
with grid-interactive photovoltaic (PV) systems where the inverter(s) meets UL 1741
requirements.
The SMART ConnectDER can be factory configured to terminate DER field wiring to either
the load side or line side of the utility meter. Refer to the ConnectDER website for more
information.
DOCUMENT VERSION
This document is titled “V3 Product Manual Smart v2.2F 091517”.
It is available online at the following URL:
connectder.com/products/connectder-products-manuals
Password:
!installer1
Installers are advised to check the URL periodically for revised versions of this document.
SYMBOLS USED IN THIS MANUAL
WARNING Designates instructions that if not followed could cause death, serious
injury or damage to property.
i
NOTE Designates helpful information.