Users Manual
Page | 31
PROVISION THE SYSTEM USING “INSTALLER” CREDENTIALS
1. Verify that utility power is present.
2. Verify the ConnectDER circuit breaker is shut. The LCD will activate only when the
circuit breaker is shut and power is applied.
a. If the ConnectDER is installed upside down, the LCD displays “FLIPPEd” as
shown in FIGURE 23. Provisioning may proceed only when the ConnectDER
is properly installed.
FIGURE 23
3. Once the ConnectDER is properly installed, the term “no CEL” will appear until the
internal cellular modem registers with the cellular network. See FIGURE 24.
FIGURE 24
4. Once the unit registers with the cellular network the term “b4 EnA” appears as
shown in FIGURE 25. The unit may now be provisioned using “Installer” account
credentials.
FIGURE 25