Users Manual

Page | 27
3. Install a Listed wet location-rated raceway connector.
4. Confirm the field wiring terminals are de-energized using an appropriate meter.
5. Install the junction box to the top of the ConnectDERâ„¢ unit using the Philips screws
furnished with the unit. Tighten the screws to 5 in/lbs. using a #2 Philips bit.
Make sure the seal is fully compressed and the box makes contact with the body of
the terminal pocket. See FIGURE 19.
FIGURE 19
i
NOTE USE A TORQUE DRIVER TO TIGHTEN THE SCREWS TO 5 IN/LBS.