Users Manual

Page | 26
INSTALL THE JUNCTION BOX AND CONNECT THE RACEWAY
i
NOTE If the raceway will be attached at a later time, install the junction box
according to steps 4 and 5, then install the junction box cover as
directed in step 4, “TERMINATE THE FIELD WIRING”). The junction
box may remain in place when installing the raceway.
1. Drill the conduit hole for the power raceway as shown in FIGURE 18. The conduit
entry be used on either side of the junction box. A ¼” pilot bit at the top of the
power groove locates the center of a ½”, ¾” or 1” trade size conduit opening.
Confirm the field wiring terminals are de-energized using an appropriate meter.
FIGURE 18
2. Drill the raceway hole using the appropriate sized hole saw. Remove any shavings
from the interior of the junction box.
i
NOTE DO NOT USE A KNOCKOUT PUNCH IT MAY CRACK OR BREAK
THE JUNCTION BOX.
Power conduit entry groove
Communications conduit entry groove