Users Manual

Page | 23
1. There is limited clearance to slide a ringless cover over both the breaker switch and
terminal pocket.
2. Once the device is set in the meter socket, slip the cover on.
3. Slowly work the cover over both the breaker switch and terminal pocket, taking
care not to gouge or damage them. To clear the breaker switch, it may be necessary
to tip the ConnectDER DOWN, and angle the top edge of the meter socket cover
towards the meter socket.
4. Then, slip the upper edge of the meter socket cover under the top lip of the meter
socket housing, and latch the cover. See FIGURE 14.
FIGURE 14