Installation manual

MFC INSTALLATION MANUAL Page 18 of 22
CONNECT
2
CAR.COM
Setup the software configuration for a single pulse on that accessory wire. On
the software, setup which convenient button on the device you want to use for
the remote start.
o SOFTWARE CONFIGURATION
The single pulse Recipe is included in the default download package of the
software. There is also a delayed single pulse recipe that makes sure you
hold down the button for a minimum delay before the pulse will be
triggered. You can use this if you want to filter random accidental key
press on the phone. You can adjust all the timing delays as needed from
the software interface.
For the trigger accessory line, set the maximum safety timeout for that
line to be 1sec. (This means that no matter what recipe/accessory
configuration is assigned to that line, the maximum time that output will
be activated is 1 sec)
5.1.2 DIRECT REMOTE START
In this setup, the MFC directly interfaces with all the necessary wires needed for a
remote Start, however in this configuration, you use up more accessory wires
compared to the triggered remote start. Also note that for this configuration to
work, some vehicles might require and ignition bypass kit to override an
electronic chipped key or any other type of factory security override.
Off
Start
Acc.
Ign.
Starter
AC/Heater
Controls
Fuel Pump
Engine
ECU
Ign.
2nd Ign.
Trans. ECU
Blue (+)
Acc1
output
Black (-) Ground Input
Red (+) 12V DC Input
Batt (+)
Figure 11: Direct Remote Start