User manual
TS64A001
Safety instructions
• Before you clean your TAG product, shut down or disconnect the
computer. Otherwise, you may scramble the desktop icons or inadver-
tently activate applications when you wipe the screen.
• Avoid setting up and using the TAG product in an area with excessive
levels of dust, humidity and smoke.
• Make sure an electrical socket is near your TAG product and remains
easily accessible during use.
• For SMART Board 8055ie-SMP interactive at panel only: The external
power supply needs to meet the Limited Power Source (LPS)
requirements of CSA/UL/IEC/EN 60950-1, when required.
• This TAG product should be used only with European TN and TT power
distribution systems.
CAUTION
Important information about your touch screen display
It is not suitable for older, IT-type power distribution systems found in
some European countries. “This system (IT-type) is widely used isolated
from earth, in some installations in France, with impedance to earth, at
230/400V, and in Norway, with voltage limiter, neutral not distributed, at
230V line-to-line.” (IEC 60950:1999) Contact qualied personnel if you’re
uncertain of the type of power system available where you’re installing
your SMART product.
You must connect the USB cable that came with your TECSLATE™ inter-
active at panel to a computer that has a USB compliant interface and
that bears the USB logo. In addition, the USB source computer must be
compliant with CSA/UL/EN 60950 and bear the CE mark and CSA and/or
UL Mark(s) for CSA/UL 60950. This is for operating safety and to avoid
damage to the TAG TS64A001
V