Instruction manual

4.2.6.4. Display Address

h other

displays. Display Address is entered locally at the display only. If two

displays have the same address, the network will not function properly and

From the previous section use

Each TACHTROL

plus

, TACHTROL 10 & 30 display on the network

requires an address from 1 to 8. When shipped each display address is 0

that when it is placed on the network it will not conflict wit

odd behavior will result.

to navigate to

Display Address . Use

to toggle between

addresses 1 through 8. If changes are complete,

depress Main

to return to the main screen.

4.2.6.5. Security Code

An eight-digit, 65,536 combination, security code adds a second and more

positive level of security. When a Security Code is entered, and the

Keypad Lock function is on, all menus act as described in section 4.2.6.3

and no access is permitted to the security menu without first entering the

code. In this condition, the user can view tachometer parameters, but

cannot change any of them. Once the security code is entered, access is

granted to the user but the Keypad Lock must still be reversed before the

user parameters can be changed. The numbers for the eight-digit security

code correspond to the

, , and arrow keys. The security code

In the event the user forgets the password they have chosen, a factory

is global to the entire network.

ecurity number is available. 11223344 will always allow access to the

nstrument. The factory code is not active until a user-defined code is

ctive.